VooDoo wrote:Imas jedan swich "speaker turn on" na samom bitten-u koji ti kaze dal se bitten pali na masteru ili na aux-u :respect: rtfm kak su meni jednom napisali stariji kolege 8)
Iz manuala
"
SPEAKER TURN ON: Switch OFF does not allow turning the device on from the MASTER high-level main input
Switch ON allows turning the device on from the MASTER high-level main input"
Ne kaže mi da pali onda baš na auxu
tarantula wrote:postavit na kompu da su činčevi glavni i amen!
Da, upravo to me zanima, ali nitko ne zna sigurno jel to tako moguće na Bit ten
Ili ovo
"
Remark: If a low-level output source (PRE OUT) with output signal equal or greater than 2 V RMS is available, you can
connect it to the high-level MASTER inputs (SPEAKERS).
Sensitivity is increased by adjusting the IN LEVEL controls"
Kako je izlaz iz HU 4V, napraviti kabel sa rca na žice (ili adapter neki ili blabla)
Ili ovo
"
Mute In / Phone Mute settings: allows you to specialize the “MUTE IN / PHONE MUTE”
terminals (default settings) for the AUX input to be automatically selected. If you choose
to use the “MUTE IN” terminal, it will be active if you apply + 12V to it. If you choose to
use the “PHONE MUTE” terminal, instead, it will be active if you apply GND to it.
According to the chosen setting modification, the corresponding default function will be
disabled."